Publicité
Les langues disponibles
Les langues disponibles
Keep a fire extinguisher near the
welding area.
Check the welding area for fire af-
ter welding (see UVV*).
Never try to disassemble the pres-
sure reducer. Replace the defecti-
ve one.
The machine must be transported
or set up only on firm, level surfaces.
The maximum admissible angle of
inclination for setting up or trans-
porting is 10°.
‰ Service and repair work may only be car-
ried out by a trained electrician.
‰ Ensure that the ground cable has good
and direct contact near the welding loca-
tion. Do not allow welding current to pass
through chains, ball bearings, steel cables
or grounding equipment; this may melt
them.
‰ Secure yourself and the welding machine
when working in elevated or inclined areas.
‰ The machine may only be connected to a
properly grounded mains supply. (Three-
phase four-wire system with grounded
neutral conductor or single phase-three-
wire system with grounded neutral con-
ductor) socket and extension cable must
have a functional protective conductor.
‰ Wear correct protective clothing, leather
gloves and leather apron.
‰ Protect the welding area with curtains or
mobile screens.
‰ Do not use this machine to thaw frozen
water pipes or cables.
‰ In closed containers, under cramped con-
ditions, and in high electrical risk areas,
only use machines with the S sign.
‰ Switch off the machine during breaks and
close the valve of the gas cylinder.
‰ Secure the gas cylinder with a chain to
prevent it falling over.
- 28 -
General regulation of use
‰ Disconnect the mains plug from the mains
before changing the place of installation
or making repairs to the machine.
Please heed the safety regulations which
apply to your country. Subject to change.
4
General regulation of
use
The device is intended to be used in trade
and industry. It is portable and may be ope-
rated with both, mains power supply and an
electric power generator.
This machine is built for MMA-welding.
With the TIG volve torch the machine can
be used for TIG welding (DC current) for fol-
lowing material:
– mild steels, low- and high alloyed
steels
– copper and its alloys
– nickel and its alloys
– material like titanium, zircon, tantalum
The device is not destined for AC-TIG wel-
ding of alu-minium and manganese.
10.15
Publicité
