LORCH Handy 200 BasicPlus Manuel D'utilisation page 35

Control panel
LED malfunction
11
lights up permanently if the unit is
overheated, flashing in case of mal-
function (see chapter for trouble re-
ports), ignition of arc is not possible.
LED remote control
12
lights up when remote control is con-
nected.
The turning knob 13 displays the maxi-
mum value for the setting range of the
control. I.e. if 100A are set, the remote
can recall 10A-100A.
Turning knob
13
for welding current adjustment for the
stepless setting of welding current.
Both to select the parameter and to
set the parameter values (Handy 200
ControlPro).
LED TIG
14
lights up if TIG mode is selected.
LED Elecrode basic
15
lights up if electrode mode is selected.
(electrodes with basic coating)
LED Elecrode rutile
16
lights up if rutile electrode mode is
selected.
(electrodes with rutile acidic coating)
LED Electrode CEL
17
lights up if CEL electrode mode is
selected.
(electrodes with cellulose coating,
suitable for vertical seams)
Key switch electrode/TIG
18
serves to select the operating mode.
To set TIG mode, keep the key pres-
ses for at least 2 seconds.
Menu/Secondary parameter button
19
used for calling up the secondary
parameters.
The 7 segment display, shows the
20
selected current intensity.
When the secondary parameters are
active, the code and the setting value
of the secondary parameter are dis-
played alternately.
10.15
LED VRD (only at machines with this
21
option)
is permanently lit if the VRD-function is
activated (voltage reduction device)
blinks if the output voltage rises abo-
ve the permitted standard value (e.g.
during the welding process)
‰ After switching on the unit
– all displays will flash for approx. 2 se-
conds for self-testing.
– the last setting will be selected
- 35 -