Publicité
Les langues disponibles
Les langues disponibles
6.2 APPLIANCE PROCESS OVERVIEW
The Cinderella appliance is designed according to fail-safe principles. In the event of component failure or
faulty control signals, the toilet will go into "safety mode". This means that the unit will not be able to start an
incineration and error messages will appear on the display, ensuring that all component and/ or signal failures
that may occur are safeguarded in the system
The appliance is equipped with hall sensors that control both the lid and ash container. These sensors are
normally open and will be triggered when in contact with the magnet(s) mounted on the outside of the container
and inside the toilet lid.
When the lid is opened, the axial fan will start to ventilate the system. After each use, the incineration is activated
by pressing the button on the control panel. The bowl liner with its waste contents is dropped from the toilet
bowl into the incineration chamber, where it is safely incinerated at a high temperature.
The hatch mechanism is controlled by two microswitches, one mounted on the top of the toilet frame to check
that the hatch is in the desired "open" position, and one mounted on the lower front end of the appliance
ensuring that the hatch is in safe, enclosed position.
During incineration, the air supplied into the appliance provides the oxygen required for proper Incineration.
The exhaust vent removes excess heat. All fumes and vapours are processed through a heat-activated platinum
catalytic converter to reduce emissions and odours.
The temperature inside the incineration chamber is closely monitored by the thermocouple mounted inside the
chamber, the temperature inside the toilet is safeguarded by the bimetal thermostat mounted on the interior
frame of the toilet.
The incineration process can take 40 – 180 minutes and is controlled automatically by the appliance's sensory
technology. The toilet can be used at any time while incinerating. The incinerating process will be paused when
the lid is opened and automatically reactivated when lid is closed. Numerous safeguards exist to ensure safe
operation. See section 3.4 of this manual.
6.3 TECHNICAL ORIENTATION
ID
PART DESCRIPTION
1
Axial fan
2
Liner placed in bowl
3
Heating element
4
Ash container
5
Hall sensor
6
Thermocouple
7
Inlet air
8
Catalytic converter
9
Outlet air
1
2
3
4
9
2
8
6
5
7
27
Publicité
