Gima MONITEUR SPOT-CHECK PC-300 Manuel De L'utilisateur page 72

Safety instruction for SpO
 Continuous use of SpO
microcirculatory problem. It is recommended that the probe should NOT be applied to the
same place for over two hours, change the measuring site periodically if necessary.
 When the ambient temperature is over 35°C, please change the measuring site every two
hours if necessary; when the ambient temperature is over 37°C, please do NOT use SpO
sensor, for long time using in high temperature will cause burns.
 SpO measuring site must be examined more carefully for some special patient. Do NOT
2
place the SpO
2
 Do NOT put the SpO
pressure measurement may affect the SpO
 The device is calibrated to display functional oxygen saturation.
 Do NOT allow the sensor cable to be twisted or bended.
 Check the SpO
2
 When the temperature of the SpO
 Please do NOT use nail polisher or other cosmetic product on the nail.
 The fingernail should be of normal length.
 The SpO sensor can not be immerged into water, liquor or cleanser.
2
 The SpO sensor can be repeatable used. Please clean and disinfect it before using.
2
☞ Connectors with the label "SpO 2 " can only be connected with the smart SpO 2 probe.
Note: The ECG and SpO
successfully connected to both the ECG accessory and the smart SpO
will take precedence over the other, for example of the user presses "Start" on the ECG
accessory, the SpO
is terminated.
ENGLISH
measurement
2
probe may result in discomfort or pain, especially for those with
2
probe on the finger with edema or fragile tissue.
probe and pressure cuff on the same limb, otherwise the blood
2
sensor and cable before use. Do NOT use the damaged SpO
2
functions cannot be used simultaneously. If the device is
2
probe will be temporarily disabled until the ECG measurement
2
measurement.
2
sensor is abnormal, do not use it any more.
sensor.
2
probe, one function
2
72
2