Gima MONITEUR SPOT-CHECK PC-300 Manuel De L'utilisateur page 70

Masquer les pouces Voir aussi pour MONITEUR SPOT-CHECK PC-300:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Continuous measurements may result purpura, neuralgia and lack blood.
 Do NOT wrap the cuff on limbs with transfusion tube or intubations or skin lesion area,
otherwise, damages may be caused to the limbs.
 The equipment is intended for pregnant or pre-eclamptic patient, but not neonatal patients.
 The need to check that operation of the equipment does not result in prolonged impairment
of patient blood circulation.
 The patient relax as much as possible and not talk during the measurement procedure.
 5 min should elapse before the first reading is taken.
 Any reading can be affected by the measurement site, the position of the patient, exercise,
or the patient's physiologic condition.
 The performance of the equipment can be affected by extremes of temperature, humidity
and altitude.
 The need to avoid compress or restriction of the connection tubing.
 Patient position in normal use, including:
1) comfortably seated
2) legs uncrossed
3) feet flat on the floor
4) back and arm supported
5) middle of the cuff at the level of the right atrium of the heart.
 The measurement should be taken at appropriate intervals. Continuous measurement
at too short internals may lead to pressed arm, reduced blood flow and lower blood
pressure, and resulting inaccurate reading of blood pressure. It is recommended
the measure be taken at intervals of more than two minutes.
 Prior to use of the cuff, empty the cuff until there is no residual air inside it to ensure
accurate measurement.
ENGLISH
70

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Moniteur spot-check pc-301Moniteur spot-check pc-30235162

Table des Matières