Siting The Appliance - Stiebel Eltron SHP-F 220 Premium Utilisation Et Installation

INSTALLATION
Preparations
Examples of unacceptable
installations
atmospheres containing ammonia sewage works, pigsties
substances which block the evap-
orator
saline environments
atmospheres containing chlorine
or chloride
atmospheres containing thermal
water
Areas in proximity to high frequen-
cy machines
Note
The appliance output data are calculated according to
standard, using the intake temperature specified in the
data table. Below this temperature the appliance efficien-
cy and output decrease. The heat-up time is extended.
Sound emissions
The sound emissions are louder on the air intake and air discharge
sides of the appliance than on the closed sides.
f Never direct the air intake or air discharge towards f
noise-sensitive rooms of the house, e.g. bedrooms.
Note
For details on sounds emissions, see chapter "Specifica-
tion / Data table".
Note
The fan speed affects noise emissions.
Never set the fan speed higher than necessary.
See chapter "Commissioning / Fan setting subject to pres-
sure drop".
9.4

Siting the appliance

Note
Accessories are located in the corners of the packaging.
Remove the accessories before disposing of the pack-
aging.
f Carefully undo the cardboard packaging at the clips. f
www.stiebel-eltron.com
air containing oil or fat, dust (cement,
flour, etc.). Note: If the air contains hair-
spray (e.g. in hairdressing salons), the
appliance should be operated at shorter
maintenance intervals.
Coastal installations (< 200 m from the
coast) can reduce component service life.
swimming pools, salt works
inverters for large motors, radar, etc.
1
1 Cardboard packaging clips
The appliance is secured to the pallet with metal brackets and
screws. The metal brackets are hooked on to the feet underneath
the floor plate of the appliance.
1
1.
1 Metal bracket fixing screw
f Remove the fixing screws of the metal brackets from the f
pallet.
f Push the metal brackets a little towards the cylinder centre to f
unhook them from the appliance feet.
f Pull the metal brackets out from underneath the appliance. f
Material losses
!
Take note of the appliance's weight and centre of gravity.
f Slightly tip the appliance and carefully roll the appliance off f
the pallet.
f Position the appliance in the final installation site. f
2.
SHP-F 220-300 Premium | 17