Renfert BASIC eco Traduction Du Mode D'emploi D'origine page 24

5 Operation
⇒ Switch the illumination on (4)�
⇒ Select the blasting tank at the selection switch (3) (only on
the 2 tanks version)�
Do not operate the foot switch during tank selection.
⇒ Take the handpiece out of the holder of the relevant sand-
blasting tank (see color markings)�
⇒ Activate the foot switch (10, Fig� 1)�
♦ The sandblasting material will flow as long as the foot
switch is activated�
5.1 Blasting notes
Flat blasting with wide nozzles:
90003-1739 1,5 x 3,5 mm [0�059 x 0�138 inch]
When blasting glass ceramics, refer to manu facturer's notes�
5.2 Select blasting pressure
⇒ Take the handpiece out of the holder of the relevant sandblast-
ing tank (see color markings)�
⇒ Activate the foot switch�
⇒ Set the sandblasting pressure at the pressure regulator (6)�
♦ The amount of pressure will be shown on the pressure
gauge (7)�
Do not exceed the maximum pressure (see „Technical Data").
In the 2 tank version the amount of pressure selected applies
for both blasting tanks.
6 Cleaning / Maintenance
Before cleaning or servicing:
► Switch off and unplug the device!
► Disconnect the appliance from the compressed air supply!
6.1 Sandblasting tank
Check the sandblasting tank or tank lid regularly, at least
1 x a year, by visually inspecting for damage or changes to
the material (e.g., cracks ...).
If in doubt, replace!
The sandblasting tank and tank lid are subject to a natural
aging process depending on ambient conditions and must be
replaced as standard after every 15 years of operation.
Note the year of manufacture on the round stamp engraved
on the sandblasting tank and in the tank lid; Our customer
service team are happy to advise you.
Example of an engraved round stamp:
Date of manufacture 01-2003
To clean:
DO NOT use solvent-based cleaning agents or disinfectants.
Solvents and tensides can result in microcracking in the plastic (danger of explosion!).
⇒ Only clean the sandblasting tank and tank lid by rubbing with a dry cloth�
4
3
- 9 -
Fig. 7
6 7
Fig. 8
Fig. 9
en