Publicité
Les langues disponibles
Les langues disponibles
4.5
Electrical connection
Note the instructions in Chap. 2.6 Risk as a result of electric shock and fire!
en
⇒ Unroll the power cable (12, Fig� 1)�
⇒ Insert the power plug into the building installed wall socket�
4.6
Connect to extraction unit
⇒ Connect the suction tube from the extraction unit to the suction
pipe (18)�
► For suction devices with automatic activation:
⇒ Connect the mains plug from the sandblasting unit into the user
socket on the suction device�
4.7
Filling the sandblasting tanks
Do not write on or stick anything to the sandblasting tank and
tank lid.
Do not press the foot switch while filling is in progress!
Regardless of the pressure display, the sandblasting tanks
are only pressurized when the foot switch is pressed.
⇒ Only fill with abrasives up to the max. fill height (thickening of the
tank cover underneath the thread)�
⇒ Clean the thread on the sandblasting tank and tank lid as well as
the seal�
⇒ Screw the tank lid closed firmly by hand.
Abrasive residue on the seal causes leakage and premature
wear of the seal.
Warning: Do not tilt the tank lid when screwing it on.
Check that the tank lid is seated securely prior to use.
Tank lids that are not closed securely can suddenly blow off.
There is a risk of injury as a result of flying parts and sudden emission of abrasive sand.
⇒ Always use only clean, dry abrasive of the appropriate grain size (refer to the accessories)�
Your blasting machine is now ready for use.
4.7.1
Authorised sandblasting material
• Cobra (Renfert GmbH)
• Rolloblast (Renfert GmbH)
• ROCATEC (3M ESPE)
Sandblasting materials from other manufacturers may be used providing the grain size, grain shape and
degree of purity comply with the above mentioned materials�
Renfert GmbH assumes no liability for the function and service life of the devices if other blasting agents
are used�
max�
- 8 -
18
Fig. 5
Fig. 6
Publicité
