Avdel Genesis G1 Manuel D'instructions page 8

N o s e A s s e m b l i e s
Nose assemblies do NOT include nose tips. Nose tips must be ordered separately.
A tool must always be fitted with the correct nose assembly and nose tip for your fastener (see diagram page 6 and 9 for part numbers),
and apart from -00039 these items will be supplied separately, refer to tables opposite.
If your application presents no access restriction use a type '1' nose tip unless you are placing an aerospace fastener which requires a
type '3' nose tip.
Dimensions 'A' and 'B' will help you assess the suitability of a particular nose tip.
You should finally check that the dimensions of the nose casing, shown page 9, will not restrict access to your application.
If access is restricted type '2' nose tips are available for some fasteners. Refer to type '2' nose tip table.
It is essential that the correct nose assembly and correct nose tip are fitted prior to operating the tool.
F i t t i n g I n s t r u c t i o n s
The air supply must be disconnected when fitting or removing nose assemblies.
Item numbers in bold refer to nose assembly components in all 3 nose tip tables, see page 9.
•
Lightly coat jaws 4 with Moly lithium grease*.
•
Drop jaws 4 into jaw housing 3.
•
Insert jaw spreader 5 into jaw housing 3.
•
Locate buffer 6 on jaw spreader 5.
•
Locate spring 7 onto jaw spreader 5.
•
Fit locking ring 8 onto the jaw spreader housing of the tool.
•
Holding tool pointing down, screw on the assembled jaw housing 3 onto the jaw spreader housing and tighten with spanner.
•
Screw the nose tip into nose casing 1 and tighten with spanner*.
•
Place nose casing 1 over jaw housing 3 and screw onto the tool, tightening with spanner*.
S e r v i c i n g I n s t r u c t i o n s
Nose equipment should be serviced at weekly intervals. You should hold some stock of all internal components of the nose assembly
and nose tips as they will need regular replacement.
•
Remove the nose equipment using the reverse procedure to the 'Fitting instructions'.
•
Any worn or damaged part should be replaced.
•
Particularly check wear on jaws.
•
Check spring 7 is not distorted.
•
Assemble according to fitting instructions.
* Item included in the G1 service kit. For complete list see page 13.
8
All manuals and user guides at all-guides.com
I M P O R T A N T
I M P O R T A N T