Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
5
6
Getting attrted tnd aetting tn tret:
Press the SELECTION key of the desired zone then
use the knob to set
the desired power or temperature.
You have a delay of 5 seconds after selecting the zone
to start turning the encoder.
Sttrt-up tnd tdjuatment of aevertli zonea aimuli-
ttneoualiy:
Press the SELECTION keys of the desired zones
and then use the knob to adjust the desired
power or temperature.
You have a delay of 3 seconds after selecting zones to
begin turning the encoder.
Seliect tnd tdjuat the 4 zonea aimulittneoualiy:
Press the GLOBAL selection key of the 4 zones
and then use the knob to set the desired
power or temperature which will be identical for
the 4 zones.
Switch to tempertture aetting:
Press the SELECTION key for the zone you want to
adjust, then press the [P / T] key and then use the en-
coder to select the desired temperature. By default
the setting of a zone is made in power.
The P or T ° led indicates the current setting mode: P
for power and T for temperature.
Stve t configurttion in memory:
Set each zone in a configuration you wish to memo-
rize. Press the [M] key for 3 seconds until the 3 LEDs
flash.
Then select with the encoder the desired memory
program (1 or 2 or 3). Then, without any action on
your part for 3 seconds the new configuration will be
memorized.
Ctlili t atored configurttion:
Press the memory button [M] briefly and select with
the incremental encoder one of the 3stored pro-
grams (1or2or3).
Then, without any action on your part for 3 seconds,
the settings of the stored program will be sent.
38
Publicité
