Adventys Induc-NoLimit Multizones KNL4 Guide D'utilisation Et D'installation page 28

Integrttion of the controli bliock
The integration of the control panel:
Dimensions of control block
The side 73 mm depth is inclusiv with connector connected to the back.
1) It is necessary to make a rectangular cut of 215 mm x 88 mm minimum, with 4 holes of diameter 7 mm,
according to the plan below:
2) Make a seal by creating a bead of glue under your control panel, with silicone sealant (type Novasil).
ADVENTYS provide t gliue ctrtridge on requeat.
3) Insert your control panel into the cutout (the 4 studs inside the 4 outcut holes).
4) Fix the control panel by screwing the nut M4 with the washers on the studs, provided for this purpose
(4 nuts + 4 washers are provided).
28