Husqvarna 967 96 64-06 Manuel D'utilisation page 19

Drive system for grinding head
The drive system for the grinding head is a closed
system. If you have problems with the drive system of
the grinding head, speak to your Husqvarna service
agent.
To install and remove the grinding head
WARNING: The chassis is not balance when
the grinding head is removed. Make sure
that the chassis can not fall. It can cause
injury or damage.
1. Put the motor cable (A) in front of the grinding head.
A
2. Push the chassis near the grinding head (B).
3. Put the motor cable through the slot between the
grinding head and the chassis.
1253 - 002 - 24.10.2019
4. Push the chassis fully against the grinding head (C).
Make sure that the chassis attaches to the bracket
on the grinding head.
5. Install the second bracket (D) on top of the bracket
on the grinding head.
6. Tighten the 2 nuts (E) on each side of the grinding
B
head.
D
C
E
19