Husqvarna 967 96 64-06 Manuel D'utilisation page 13

• Servicing position of the handle:
To adjust the handle and the handlebar
WARNING: Be careful when you adjust the
handle and the handlebar. Make sure that
the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
1253 - 002 - 24.10.2019
A
B
4. Loosen the 4 screws (C) on the handlebar.
D
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
3. Engage the support frame. Refer to
disengage the support frame on page 9 .
4. Hang the power cord on the suspension device on
the support frame to prevent tension in the power
cord.
5. Disengage the support frame.
CAUTION: When the product is connected
to a dust extractor, the dust extractor must
be connected to a 3-phase power source.
E
To engage and
13