Husqvarna 967 96 64-06 Manuel D'utilisation page 12

12. Attach the tool plate straight (E) on the grinding disc.
13. Turn the tool plate (F) to the right or to the left to lock
the tool plate to the grinding disc.
14. Carefully lift the product to operation position. Use
the handlebar and the support frame for support.
15. Disengage the support frame.
To connect a dust extractor
WARNING: Do not use the dust extractor if
the dust extractor hose is damaged. The risk
increases that you breathe in dust that is
dangerous to your health. Use approved
respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the STOP/RUN switch on the control
panel is set to 0.
4. Connect the dust extractor hose to the product.
5. Engage the support frame. Refer to
disengage the support frame on page 9 .
12
6. Hang the dust extractor hose on the suspension
E
F
7. Disengage the support frame.
Handle positions
•
•
To engage and
device on the support frame to prevent tension in the
dust extractor hose.
Operation position of the handle:
Transport position of the handle:
1253 - 002 - 24.10.2019