Jeulin 223 008 Mode D'emploi page 62

Ultrasounds
Moduson table
Ref :
223 008
3.1 Step 1: Setup
 The system is set up as follows:
The transmitter 2 is positioned on a magnetic support inclined at 45 deg. This special
position is necessary to achieve short distances between the two transmitters. Thus they
contact each other in their smallest spacing (2 cm).
The transmitter 2 is connected to the main transmitter. The main transmitter is powered via a
15 V power supply and its switches are set on Continuous and OFF, respectively (its
transmitting element is then cut off and only the transmitter 2 is powered).
The receiver is positioned in the circular recess closest to the transmitter (radius = 15 cm) in
which it can be moved. It is positioned on the zero graduation. It is connected by means of a
shielded cable to the vertical input of the oscilloscope.
 Material:
List the equipment used.
 Complete the setup schematic
(plot the 2 sound radiations that reach an arbitrary point M)
ENGLISH
15 V
S1
θ
M
S2
O
Mo
59