Arcam A85 Manuel D'instructions page 13

All manuals and user guides at all-guides.com
Service information
Before returning your amplifi er for service, please check the
following:
Sound cuts out for no reason
If the temperature of the internal heatsink rises above a safe
level, then a thermal cutout inside the amplifi er will operate.
The power indicator on the front panel fl ashes and the
protection system temporarily removes the power to the
speakers. The system resets itself as the heatsink cools down.
Technical specifi cations
Continuous power output, per channel
Both channels, 8Ω, 20Hz–20kHz
Single channel, 4Ω, 1kHz
Distortion, 8Ω, 80% power, 1kHz
Inputs
Phono cartridge (optional module):
input sensitivity, MM
input sensitivity, MC
Line and tape inputs:
Nominal sensitivity
Input impedance
Signal/noise ratio (CCIR)
Tone controls, max. boost/cut
Preamplifi er outputs
Nominal output level
Output impedance
General
Power consumption (maximum)
Dimensions W x D x H (including feet)
Weight (net)
Weight (packed)
Supplied accessories
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products.
This means that designs and specifi cations are subject to
change without notice.
A85/P85 multi.id 13
Note that because of the high output voltage from a CD player,
it is possible to drive the A85 at full power even though the
volume is not set at maximum.
Amplifi er does not switch back on
The A85 and P85 amplifi ers have a protection mechanism
which is activated if you switch the unit on immediately after
turning it off. If this mechanism activates, wait 30 seconds
then try again.
A85 P85
85W 85W
140W 140W
0.005% 0.005%
2.5mV
250µV
250mV 700mV
22kΩ 22kΩ
105dB 112dB
±12dB
700mV
<3Ω
800VA 800VA (950VA for P85/3)
435 x 340 x 100mm 435 x 320 x 100mm
9kg 9.5kg (10.5kg for P85/3)
10.5kg 11kg (12kg for P85/3)
mains lead mains lead
CR-389 remote control
2 x AAA batteries
NOTE: All specifi cation values are typical unless otherwise
stated.
03/29/01, 3:46 PM
A85/P85
13