Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Bi-wiring and bi-amping loudspeakers
Before you start
WARNING: Do not make any connections to your
amplifi er while it is switched on or connected to the
mains supply.
Before switching on please check all connections
thoroughly, making sure bare wires or cables are not
touching the amplifi er in the wrong places (which could
cause short circuits) and you have connected positive
(+) to positive and negative (–) to negative.
Always ensure that the volume control on your
amplifi er is set to minimum before starting these
procedures.
Bi-wiring your loudspeakers
Bi-wiring improves the sound of your system because it divides
the high and low frequency signal currents into separate
speaker cables. This avoids signal distortions arising from the
high and low frequency currents interacting with one another
within a single cable, as in conventionally wired systems.
You will need:
Speakers – with four input terminals each: these will be marked
HF (High Frequency) and LF (Low Frequency).
Loudspeaker cables – two pairs of cables per loudspeaker
(which may be joined at the amplifi er end if your amplifi er has
only one pair of output terminals per channel). Or, a suitably
terminated cable set (a loom, probably prepared by your dealer
and capable of being used for bi-wiring in one length).
How to bi-wire loudspeakers
1.
Remove the terminal links on the rear of your
loudspeakers
WARNING: This step is essential or damage to
your amplifi er may result which is not covered
under warranty.
2.
Connect the cables as shown in the diagram below,
ensuring correct polarity at all times.
+
+
HF
+
LF
Bi-wiring using one set of connections on amplifi er
A85/P85
12
A85/P85 multi.id
12
Arcam A85 amplifier
–
+
–
R
L
–
+
–
HF
Right
Left
speaker
speaker
–
+
–
LF
Bi-amping your system
The performance of your system can be further enhanced over
that achieved with bi-wiring, by extending the principle one
stage further to include separate amplifi cation for the low and
high frequency drive units in each loudspeaker enclosure.
Connect the integrated amplifi er to the high frequency (HF)
terminals and connect the power amplifi er to the low frequency
(LF) terminals.
You will need:
Speakers – with four input terminals each (as with bi-wiring):
these will be marked HF (High Frequency) and LF (Low
Frequency).
Two amplifi ers – one of these would be the A85 and the other
an Arcam power amplifi er (e.g. P85).
Loudspeaker cables – two pairs of cables per loudspeaker or
a suitably terminated cable set (a loom, probably prepared by
your dealer and capable of being used for bi-amping in one
length).
Interconnect cables – one pair of high quality interconnect
cables.
How to set up a bi-amped system
1.
Remove the terminal links on the rear of your
loudspeakers.
WARNING: This step is essential or damage to
your amplifi er may result which is not covered
under warranty.
2.
Connect the cables as shown in the diagram below,
ensuring correct polarity at all times.
3.
Use the interconnect cables to connect the
PRE OUT
sockets of the A85 to the corresponding
AUDIO IN
sockets of the power amplifi er.
Amplificateur Arcam A85
+
–
+
–
L
R
+
–
+
–
HF
HF
Enciente
droite
–
LF
LF
+
–
+
–
+
–
+
–
R
L
Amplificateur de puissance Arcam P85
Recommended bi-amping confi guration
03/29/01, 3:46 PM
Enciente
gauche
Publicité
