Arcam A85 Manuel D'instructions page 11

All manuals and user guides at all-guides.com
Using your P85 power amplifi er
POWER (and power indicator light)
Switches the unit on and off. The light indicates the status of
the amplifi er.
When you switch your amplifi er on, the light glows amber for a
few seconds, during which time the speakers are disconnected.
The light changes to green when the amplifi er is ready for use.
A red light means the amplifi er is in standby mode.
The light may fl ash if a fault has occurred – the fault type is
shown on the display. You should unplug the amplifi er and leave
it for a few minutes before reconnecting. If the fault cannot be
cleared, unplug your amplifi er and contact your Arcam dealer.
A85/P85 multi.id 11
P85 POWER AMPLIFIER
SP1 SP2
SP1 and SP2
These buttons allow you to select and deselect the main
( SP1 ) and secondary ( SP2 ) sets of speakers attached to your
amplifi er. An indicator light shows which set of speakers are
currently selected.
NOTE: If both lights are out the amplifi er will appear not to
work, as all speakers are switched off. If both are on, and
low impedance speakers are connected, overloads are more
likely.
03/29/01, 3:44 PM
POWER POWER
POWER
A85/P85
11