Publicité
Les langues disponibles
Les langues disponibles
• On the other hand, if your weight increases in the medium term and your body fat percentage drops or
stays the same, you may have built up valuable muscle mass.
• If your weight and body fat percentage both fall at the same time, then your diet is working – you are los-
ing fat mass.
• Ideally, you should support your diet with physical activity, fitness or strength training. This enables you
to increase your muscle percentage in the medium term.
• Body fat, body water and muscle percentages must not be added (muscle tissue also contains compo-
nents made of body water).
10. More information
User assignment
It is possible to assign up to 8 scale users for a weight-only measurement (with shoes) and for a diagnosis
measurement (bare feet).
For a new measurement, the scale assigns the measurement to the user whose most recently saved
measurement falls within ± 3kg of this. See chapter 8.
Storing the assigned measurements on the scale and transferring them to the app.
If the app is not open, the newly assigned measurements are saved on the scale. A total of 30 measure-
ments per user can be saved on the scale. The saved measurements are transferred automatically to the
app if you open the app within the Bluetooth range.
It is possible to automatically transfer data when the scale is switched off.
Deleting scale data
• Delete all
Step on the scale briefly; "0. 0 " appears. Hold the Unit/Reset/Delete button on the rear of the scale for
approx. 5 seconds. „
All saved values and settings are deleted.
You must then carry out the actions in chapter 6 again (user assignment).
• Delete individual users
Step on the scale briefly; "0. 0 " appears. Press the "
the "SET button". When "0. 0 " and your initials are displayed, hold the Unit/Reset/Delete button on the
rear of the scale for approx. 3 seconds. „
All saved values and settings are deleted.
You must then carry out the actions in chapter 6 again (user assignment).
Changing the batteries
Your scale is equipped with a low battery indicator. If you operate the scale with flat batteries, "Lo" will
appear on the display and the scale will automatically switch off. In this case, the batteries must be
replaced (4 x 1.5 V AAA). All saved measurements and users remain saved.
Connect the scale to the app again. The system time is updated.
NOTE:
• When changing the batteries, use batteries of the same type, make and capacity.
• Do not use rechargeable batteries.
• Use batteries free from heavy metals.
11. Cleaning and maintaining the device
The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher!
" will appear on the display for several seconds.
" appears in the display.
" buttons to select your user and confirm with
21
Publicité
