Charging Batteries; Unit And Fixing System Description - Midland BTX2 PRO Guide D'utilisation

Wire connections:
› For stereo audio input like iPod/MP3 player (with optional cable)
Attention: Midland BTX2 PRO is designed to withstand rain and water. However, if it is rai-
ning, always verify that the rubber cap protecting the recharging sockets is fully fitted.

Charging batteries

Attention: Make sure that the unit is fully charged before use. Allow at least 3 hours for a full
charge before using the unit for the first time.
Charge the unit by inserting the wall-charger into the charging socket (lift the rubber
cover to insert the plug). The red LED on the unit will start flashing when charging begins.
Allow the headset to charge until the unit stops flashing or the blue LED turns on.
When the charge is complete (the red LED is not flashing), release the headset from the
charger. Normally, after the first time, it takes 2 hours for a full charge.
Attention: every time the micro USB recharging plug is inserted (or detached), the device
is automatically turned off. To use it while it is in charge, you should turn the device on with
the plug already inserted.

Unit and fixing system description

BTX2 PRO description
The BTX2 PRO has five buttons on the front; the main three big buttons are multi fun-
ctions buttons: the Forward (on the left), the middle button and the Backward (on the
right), the two squared buttons are the Volume + and Volume -.
Volume -
Forward Middle
www.midlandeurope.com
Volume +
LED
Backward
Description of the wired connections
On the bottom of the unit you can find the Charger jack that enables to recharge the unit
using a standard microUSB power supply
The same micro USB charger plug can be used to connect an audio source, like a stereo
iPod/MP3 player;
Attention: you need an optional AUX cable not included in the box.
Description of the audio kit
The audio system includes two ultra-flat stereo speakers and two interchangeable
microphones, which are both supplied with a bracket and wired connection. The mini
connector on the microphone allows you to choose the microphone that best suits the
helmet you are using.
Fixing the stereo speakers
The two stereo speakers have a Velcro/adhesive strip that aids their fixing into your hel-
met. Beware not to completely cover your ear with the speakers, you must always be able
to listen to the traffic sound and your indicators.
The microphone can be fixed onto the helmet in two ways:
Charger plug
19