Midland BTX2 PRO Guide D'utilisation page 25

1
Conference
The "Conference" mode allows the communication with four people simultaneously. The
Midland BTX2 PRO unit can work as usually, with "one to one" communication up to 4
1
people ("classic" Intercom mode) or with 4 people conference intercom (Conference
mode).
How to use the conference mode
First of all you need to pair all the units in a "chain" mode, second the "Conference"
feature must be active on all the units paired.
Pairing
To use the conference mode you need to pair all the units in a "chain" configuration. The
BWD button of the first unit must be paired to the FWD button of the second unit. The
BWD button of the second unit must be paired to the FWD button of the third unit and
so on, till the fourth!
1
2
The first and the last unit must not be paired together (the chain must stay open).
The unit number 1 can talk to the last unit (number 4) only "through" the unit number
2 and number 3. That means to have the conference with four people, all the unit must
have the intercom open.
24
3
2
3
2
3
4
Activate Conference mode
In "Intercom Mode" and no active audio, keep pressed the FWD button for 7 sec. The
voice announcement "Conference" will tell you that it is active.
When the Conference mode is active the "Phone" mode is not available because all the
devices paired on Vol+ and Vol – are temporary disconnected to guarantee the stability
of the conference mode.
Disable the "conference" mode
The conference mode can be disabled in every moment, just pressing the FWD button
for 7 sec. You will hear the voice announcement "Intercom" and from that moment your
Midland BTX2 PRO will start working with "one to one" intercom and all the devices
paired on Vol+ and Vol- are back, together with the "Phone" mode and the "Talk2All-U-
niversal intercom" feature.
Attention: when the "conference" mode is active, the "Talk2All- Universal Intercom" (to talk
with not Midland brand intercom) is not available.
Also if one unit was paired on the CTRL (middle) button, it is temporary unavailable,
you need to disable the "Conference" mode and go back to the standard "one to one"
Intercom mode.
How to use the conference mode
When the conference mode is active, is possible to open the intercom communication
pressing both the FWD and BWD button. One click on the button will open the inter-
com communication, one click on the same button will close it.
The two units that are in the middle of the chain (unit 2 and 3) must keep the intercom
open on both FWD and BWD button to allow the full communication of the four units
together.
"One Click Talk" function
When the conference mode is active, it is possible to open the intercom communication
to all the 4 users just in "one click". Press short the CTRL (middle) button and you will
automatically open the conference to all the unit connected.
www.midlandeurope.com