Charging Batteries; Unit And Fixing System Description - Midland BTX2 PRO S Guide D'utilisation

Bluetooth devices:
Mobile phone with MP3 player Stereo (A2DP protocol) and GPS navigator

Charging batteries

Attention: Make sure that the unit is fully charged before use. Allow at least 3
hours for a full charge before using the unit for the first time.
Charge the unit by inserting the wall-charger into the charging socket (lift the
rubber cover to insert the plug). The red LED on the unit will start flashing
when charging begins.
Allow the headset to charge until the unit stops flashing and the blue LED
turns on.
When the charge is complete (the red LED is not flashing), release the head-
set from the charger. Normally, after the first time, it takes 2 hours for a full
charge.
Attention: Midland BTX2 PRO S is designed to withstand rain and water. Howe-
ver, if it is raining, always verify that the rubber cap protecting the recharging
sockets is fully fitted.
Attention: every time the micro USB recharging plug is inserted (or detached),
the device is automatically turned off. To use it while it is in charge, you should
turn the device on with the plug already inserted.
www.midlandeurope.com

Unit and fixing system description

BTX2 PRO S description
The BTX2 PRO S has five buttons on the front; the main three big button
are multi functions buttons: the Forward (on the left), the middle button and
the Backward (on the right), the two squared buttons are the Volume + and
Volume -.
Volume -
Forward Middle
On the bottom of the unit you can find the Charger jack that enables to re-
charge the unit using a standard microUSB power supply
Description of the audio kit
The audio system includes two HI-FI stereo speakers and two interchangeable
microphones, which are both supplied with a bracket and wired connection.
The mini connector on the microphone allows you to choose the microphone
that best suits the helmet you are using.
Volume +
LED
Backward
Charger plug
19