Washable Active Carbon Filter Care - Sharp FP-R65CX Manuel D'utilisation

WASHABLE ACTIVE CARBON FILTER CARE

HAND WASH ONLY!
DO NOT TUMBLE DRY!
Care Cycle
When the Active Carbon Filter Indicator Light
lights up, this indicates that the filter needs to
be cleaned. If the unit is kept on 24 hours a
day then the Filter Indicator Light will activate
in about 2 months.
The Active Carbon Filter Indicator Light is for
reference. Clean the filter as often as neces-
sary when odour persists.
1
Fill a large container with warm
water, add a mild kitchen deter-
gent and stir.
Dilute as indicated
on the detergent
container.
2
Allow the filter to soak approxi-
mately 30 minutes before wash-
ing.
If the filter surface is
very dirty, scrub with
an old toothbrush.
3
Rinse thoroughly with
clean water.
CAUTION
If rinsing in a container, be
sure to rinse 3 to 4 times
so that the odour is rinsed
thoroughly from the filter.
4
Remove excess water.
The filter will be saturated with water after
rinsing. To decrease drying time, wrap the
filter in an old thick towel so that excess
water can be removed.
CAUTION
Some carbon may ad-
here to the towel, but it
is harmless.
5
Dry the filter outdoors
if possible in a well
ventilated area.
CAUTION
• The wet filter is heavy. Fix it securely for
drying to make sure it does not fall down.
• The filter takes longer to dry in winter, on
rainy days. Wash it on a day when the
weather is good and dry it in the sun.
Move it indoors at night to prevent freez-
ing.
• Dry the filter outdoors in a well ventilated
area. If dried indoors, the water dripping off
the filter may soil your floor.
• Make sure that the activated carbon has
not shifted to one side inside the filter. If it
has, distribute it evenly with your fingers.
• Let the filter dry thoroughly.
If used while the filter is still moist, then the
air that is exhausted from the main unit will
have an odour. It may take 1 or 2 days to
dry.
6
Reinstalling the Filters.
Reinstall the filters as shown on Page
E-8,9
Connect the power cord to the
7
outlet and press the Active
Carbon Filter Reset Button on the
main unit.
• Once the Active Carbon Filter Reset
Button has been activated, you will
hear a beep sound that means the unit
has been reset.
• The Active Carbon Filter indicator light
will then go out automatically.
Filter Reset Button
E-19