EUROM 342185 Manuel D'utilisation page 34

The remote control works on a cell battery, type CR2025 (3V).
Location and connection
 Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 The device has to be hung from a wall and therefore may not be used in a lying,
leaning or standing position!
The heater has to preferably be positioned at and permanently connected
to an electric socket. This connection may only be made by a qualified
electrician and, for that reason, is not described here. In this manual, for
reasons of safety, use with a plug should be assumed; when there is a
permanent connection, any passages about the plug do not apply.
 Drill two holes in the wall at the required locations to fit the plugs exactly: make
sure these holes are horizontal and 57.5 cm apart. Insert plugs and screws into
the holes. Allow the screws to stick out by 10 mm. Hook the heater over the
screws using the hanging eyes, then lower it down and slide it to the right. The
fixing material supplied is suitable for brick walls. Consult a specialist, for
instance at a DIY store, if your wall is built of other material.
 Check whether the heater is secured to the wall; if necessary insert the screws
a little further into the plugs.
 Attach the heater using the materials supplied. Place
the bracket on top of the heater (see picture) with the
short side against the wall. Mark the location of the
hole on the wall and remove the heater. Drill a hole at
the marked spot and insert a plug. Now hang the
heater in place and screw the bracket to the wall, as
shown in the diagram. The heater is now installed.
Using for the first time and operation
 Make sure that the main switch is OFF (O)
 Unroll the electrical cable entirely and insert the plug into a suitable 220-240V
socket.
 Set the main switch to ON (l). The display will show the current temperature.
With the remote control
 Press the ON/OFF button (7): the fan will begin to rotate and the fan indicator
lamp A will light up.
 By pressing the MODE button one or more times, you can set the heater to half
of full power or select just fan. The indicator lamp for the chosen mode will light
up.
34