EUROM 342185 Manuel D'utilisation page 30

flames. Check regularly to ensure that the wall and ceiling are not
overheating; this could be dangerous!
7. Only use the device if it has been secured properly. Make sure that
you always use attachment materials that are suitable for the
surface you are working with; consult an expert if required.
8. With wall installation: never block the space between the device
and the wall.
9. Never install this device behind a door or by an open window,
where rain could get in.
10. If this device is connected directly to your electrical installation, it
must be installed by a specialist, taking into account the valid
regulations/legislation.
11. Do not place the device near, under or facing an electrical socket
and not in the vicinity of an open fire or heat source.
12. Do not use the device nearby or facing furniture, curtains, paper,
clothing, bedding, towels or other flammable materials. Keep at
least 1 metre from device!
13. Do not use the heater outdoors or in areas that are smaller than
15m³.
14. The device contains hot and/or glowing and sparking components.
Do not, therefore, use where fuels, paint, flammable fluids and/or
gases are stored. Do not use the device in an environment that
poses a fire risk, e.g. near gas tanks, gas pipes or aerosols. This is
an explosion and fire risk!
Warnings - use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
3. Some parts of this device will get very hot and could cause
burns. You must pay particular attention to children,
vulnerable persons and pets that are present near the
device. Never leave them alone with a working device.
4. Never cover or block the device; it will overheat and this could lead
to a fire risk. Never hang or place objects such as clothing, towels,
blankets, cushions, paper, etc. on the device. The minimum
distance of 1 metre between the device and flammable materials
must always be applied. Ventilation openings should never be
blocked as this may pose a fire risk. Never use the device to dry
30