GE 21018 Guide De L'utilisateur page 12

I H
NSTALLING THE ANDSET
NOTE: You must connect the handset battery before use.
1. Push down on the top of the battery compartment cover (located on the
back of each handset) and remove the cover.
2. Lift the battery pack and connect it's plug to the jack inside the compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment as shown in the illustration.
3. Close the battery compartment by pushing the cover up until it snaps
into place.
4. Place the handsets in the charging cradles.
Allow handsets to charge for 16 hours prior to first use. If you don't
properly charge the handsets, battery performance is compromised.
PRESS DOWN
FIRMLY
NOTE: If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment.
"NO BATTERY" shows in the display when the handset is placed in the
charging cradle.
12
All manuals and user guides at all-guides.com
B
ATTERY
BATTERY
BLACK WIRE
RED WIRE