Samsung DVD-R150 Manuel De L'utilisateur page 15

Connecting & Setting Up
Connecting the DVD Recorder
This section involves various methods of connecting the
DVD Recorder to other external components and required
initial setting modes.
1. Disconnect the aerial cable from your TV and connect it to
on the rear panel of the DVD Recorder.
2. Connect of the DVD Recorder and the aerial input of
your TV using the supplied aerial cable.
3. Use the Video/Audio Cable to connect ANALOG AUDIO
OUT(R/L)/VIDEO OUT jacks on the DVD Recorder to the
Audio &Video jacks on the TV.
4. Plug in the DVD Recorder and TV.
5. Turn on the DVD Recorder and TV.
6. Press the INPUT SEL. button on your TV remote control until the
Video signal from the DVD Recorder appears on the TV screen.
To RF IN
RF Cable
TV
■
The RF cable connection of this DVD Recorder sends
only signals of TV.
You must connect Audio/Video cables to watch a
signal from your DVD Recorder.
■
TV mode
Press the TV/DVD button on remote control, then
"TV" appear on Front LED display (or turn off DVD
Recorder).
Wall
DVD Recorder
or or
English - 15
Other type of connecting
the Video output cable
There are several ways to output video signal.
Select one of the following video connecting that best suits
you below.
• Case 1 : Connecting to a Video (Composite) output jack
• Case 2 : Connecting to an S-Video output jack
• Case 3 : Component Video output jacks
S-Video, Component video and Progressive
Output Modes
• S-Video and Component video output are available only if
your TV supports S-Video input or Component video input,
respectively. If S-Video or Component video output does not
work, check the TV connections and the TV input selection
settings.
• Compared to standard interlaced video, progressive scan
doubles the amount of video lines fed to your TV, resulting in
a more stable, fl icker-free, clear image than interlaced video.
This is only available with TVs that support progressive scan.
• Progressive Scan Output (576p)
Consumers should note that not all high defi nition television
sets are fully compatible with this DVD Recorder and may
cause artifacts to be displayed in the picture, in case of
576 progressive scan picture problems, It is recommended
that the user switch the connection to the 'standard
defi nition' output. If there are questions regarding our TV set
compatibility with this model 576p DVD Recorder, please
contact our customer service centre.