Publicité
Les langues disponibles
Les langues disponibles
UNAVAILABLE
UNKNOWN NAME/
CALLER/NUMBER
WAITING HANDSET Prompt telling you to enter registration mode of handset.
REGISTRATION
Handset Sound Signals
Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the problem
might be your wiring or local service.
• The cordless handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack installed correctly.
• Did the handset beep when you pressed the TALK/CALL BACK or SPEAKER
button? The battery may need to be charged.
• Place handset in charge cradle for at least 0 seconds.
Dial tone is OK, but can't dial out
• Make sure the TONE/PULSE setting on the base is set to the type of phone
service you are subscribed to.
All manuals and user guides at all-guides.com
Indicates the handset is out of range. Or an additional handset
is in use. Or there has been a base power failure, in which case
you must place all handsets on the main base cradle for 0
seconds to re-establish link with the base.
The incoming call is from an area not serviced by Caller ID or
the information was not sent.
Meaning
Signals an incoming call
Page signal
Low battery warning
41
Publicité
