Publicité
Les langues disponibles
Les langues disponibles
1. Start the product. Refer to
page 15 .
2. Wait until the ammeter is in idle position.
3. Stop the product. Refer to
page 18 .
ON/OFF buttons of the blastmotor
The ON/OFF buttons of the blastmotor are used to start
and stop the blastmotor. Refer to
ON/OFF buttons of the blastmotor on page 9 .
To do a check of the ON/OFF buttons of the blastmotor
Product overview on page 3 for information
Refer to
about where the ON/OFF buttons are on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 15 .
3. Push the ON button of the blastmotor.
4. Make sure that the motor starts and the light (A)
comes on.
5. Stop the motor. Refer to
18 .
6. Make sure that the motor stops when you push the
OFF button.
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2087 - 002 - 05.04.2023
To start the product on
To stop the product on
To do a check of the
To start the product on
A
To stop the product on page
Operation
Before you operate the
To do a check of the ON/OFF switch
Product overview on page 3 for information
Refer to
about where the ON/OFF switch is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Turn the ON/OFF switch to ON postion.
3. Make sure that the power supply starts.
4. Turn the ON/OFF switch to OFF position.
5. Make sure that the power supply stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Do the maintenance of the product on stable level
ground. Make sure that the product cannot move.
•
Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
•
Replace damaged, worn or broken parts.
•
Do not use a pressure washer to clean the product.
•
Only use lint-free cleaning cloths.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. If the product is operated in connection with a power
source, make sure that you read and understand the
operator's manual of that power source.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
5. Make sure that only approved persons are in the
work area.
Read the warning
9
Publicité
