Publicité
Les langues disponibles
Les langues disponibles
2. Remove the 2 nuts, the 4 washers, the 2 cage
clamps and the control cage.
3. Install the control cage in the opposite sequence.
To replace the blastwheel
1. Remove the feed spout and the control cage. Refer
to
To remove and install the control cage on page
20 .
2. Remove the 3 nuts, the control cage lever, the 4
washers and the lastwheel cover.
3. Put an applicable tool in the blastwheel to prevent
rotation. Remove the bolt and discard it.
2087 - 002 - 05.04.2023
4. Remove the blastwheel.
5. Install the new blastwheel in the opposite sequence.
CAUTION:
when you install a new blastwheel.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 18 .
2. Remove the V-belt cover.
3. Examine the V-belts for damages and wear. Replace
the V-belts if it is necessary.
Always use a new bolt
Do not operate the product
To stop the product on
21
Publicité
