Husqvarna 1-8DPS30 Manuel D'utilisation page 22

4. Push the V-belts with your tumb to examine the
tension. If you can push the V-belts a distance of
10–15 mm (A), the tension is correct.
5. If the V-belts tension is not sufficient, increase the
distance between the motor and the bearing.
6. Install the V-belt cover.
To replace the V-belts
WARNING:
belt cover when the power supply is
disconnected and the blastmotor has fully
stopped.
WARNING:
without the V-belt cover installed.
1. Remove the V-belt cover. Refer to
the V-belt tension on page 21 .
2. Reduce the distance between the blastmotor and the
bearing to release the tension of the V-belts.
3. Remove the old V-belts and install the new V-belts.
4. Increase the distance between the blastmotor and
the bearing to apply tension to the V-belts. Refer to
To do a check of the V-belt tension on page 21 .
5. Attach the V-belt cover.
To do a check of the chain tension of
the drive system
WARNING:
without the chain cover installed.
22
A
Only remove the V-
Do not operate the product
To do a check of
Do not operate the product
1. Stop the product. Refer to
page 18 .
2. Remove the chain cover.
3. Push the chain to examine the tension. If you can
push the chain a distance of 5 mm, the tension is
correct.
4. Loosen the nuts.
5. Move the chain wheel to adjust the tension.
6. Tighten the nuts.
7. Install the chain cover.
To stop the product on
2087 - 002 - 05.04.2023