Husqvarna 1-8DPS30 Manuel D'utilisation page 19

3. Turn the ON/OFF switch to the OFF position.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 6 .
WARNING:
maintenance, stop the motor and disconnect
the power plug from the power supply. Make
sure that all drives stop.
General product maintenance
Make sure that nuts and screws
are tight.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the RCD.
Examine the electric motor for
dirt and damage.
2087 - 002 - 05.04.2023
Maintenance
Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
service
* *
*
*
*
*
Each 3
Yearly
months
19