Publicité
Les langues disponibles
Les langues disponibles
WARNING:
steel toe-cap and non-slip sole.
WARNING:
up and down ramps manually with the drive
system disengaged. Only move the product
manually on level ground.
1. Disengage the drive system. Refer to
drive system on page 10 .
2. Push the handle downwards.
3. Push or pull the product by the handle.
4. Engage the drive system. Refer to
drive system on page 10 . With the motor off, this
has the function of a parking brake and prevents
accidental movement of the product.
To move the product with the drive
system
WARNING:
there is a risk of injury if the product falls. Be
careful when you move around the product.
WARNING:
the ground during operation.
WARNING:
forward during operation.
WARNING:
steel toe-cap and non-slip sole.
1. Engage the drive system. Refer to
drive system on page 10 .
2087 - 002 - 05.04.2023
Use protective boots with
Do not move the product
To engage the
To engage the
The product is heavy and
Do not lift the product of
Do not move the product
Use protective boots with
To engage the
2. Pull down the handle to lift the product from the
surface.
3. Set and adjust the movement speed with the speed
control dial (C).
A
4. Push and hold the drive system lever (D) to move
the product rearward.
5. Push and hold the overdrive button (A) to move at
maximum speed.
6. Push and hold the forward button (B) to move the
product forward.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
•
To move the product down a ramp, operate the
product forward slowly.
•
To move the product up a ramp, operate the product
rearward slowly.
•
Do not turn the product to the left or to the right more
than 45° on a ramp.
B
C
D
Be very careful when you
For ramps with a steep
25
Publicité
