Husqvarna 1-8DPS30 Manuel D'utilisation page 16

5. Set the ON/OFF switch on the electrical enclosure to
the ON position.
6. Engage the drive system. Refer to
drive system on page 10 .
7. Push the ON button to start the blastmotor.
8. Wait until the ammeter is in idle position.
9. Make sure that the direction of rotation of the
blastmotor is correct. Refer to
direction of rotation of the motor on page 14 .
10. Turn the speed control dial to set the drive speed.
To operate the product
WARNING:
rearward operation only. Do not move the
product forward during operation.
16
To engage the
To do a check of the
This product is for
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
1. Make sure that the work area is safe. Refer to
area safety on page 7 .
2. Fill the abrasive separator with abrasive. Fill the
separator with abrasive when necessary. Refer to
fill the product with abrasive on page 14 .
3. Start the product. Refer to
page 15 .
4. Engage the drive system. Refer to
drive system on page 10 .
5. Operate the drive system lever.
6. Pull the abrasive control lever to open the abrasive
To operate the abrasive valve on
valve. Refer to
page 12 .
7. After 2 m, close the abrasive valve and stop the
product.
8. Do a check of the blast pattern. Adjust the blast
pattern if necessary. Refer to
pattern on page 17 .
9. Select the correct speed. Refer to
correct speed on page 15 .
Do not lift the blasthousing
Work
To start the product on
To engage the
To adjust the blast
To select the
2087 - 002 - 05.04.2023
To