Toro 58620 Manuel De L'opérateur page 7

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Raising the Handle
No Parts Required
Procedure
1. Hold the handle with 1 hand and use the other to
loosen both handle-adjustment knobs until the
ratchet teeth are disengaged. Do not remove
the knobs.
2. Raise the handle and adjust it to the desired
position and align the ratchet teeth. Ensure that
both sides are level.
Important:
Ensure the cables are not
pinched between the upper and lower
handles.
3. Tighten the knobs and ensure that the handle
pivots lock in place.
Description
No parts required
Discharge chute
Screw
Engine oil
Qty.
–
Raise the handle.
1
Install the discharge chute.
4
1 Add oil to the engine.
1. Handle-adjustment knob (2)
5
Use
Figure 3
g393640