Toro 58620 Manuel De L'opérateur page 17

Servicing the Spark Plug
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
the spark plug(s) and a gapping tool/feeler gauge to
check and adjust the air gap. Install a new spark
plug(s) if necessary.
Type: Champion RN9YC or equivalent
Air gap: 0.75 mm (0.03 inch)
Removing the Spark Plug
1. Disconnect the spark-plug wire from the spark
plug.
Figure 15
1. Spark-plug wire
2. Clean around the spark plugs to prevent dirt
from entering the engine and potentially causing
damage.
3. Remove the spark plug.
Checking the Spark Plug
Important:
Do not clean the spark plug(s).
Always replace the spark plug(s) when it has a
black coating, worn electrodes, an oily film, or
cracks.
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means the air cleaner is dirty.
Set the gap to 0.75 mm (0.03 inch).
Figure 16
Installing the Spark Plug
g339525
g206628
15
Figure 17
g027480