Nilfisk Liberty SC50 UVGI Mode D'emploi page 10

A - ENGLISH
UV BULB REPLACEMENT - CONTINUED
Bulb Installation
CAUTION!
New bulbs have a protective coating around them. DO NOT remove this protective wrap from the bulb.
1. Place a new bulb into the bulb housing. Ensure correct alignment with the socket then carefully press the bulb into the socket.
2. Reinstall the bulb clamps (2) on both ends of the bulb.
3. Identify which bulb was replaced by using the Bulb Identification Number (C). With the machine ON and the bulb housing still
removed from the machine press and hold for 10 seconds the Bulb Life Rest Button (A) which corresponds to the bulb number
that was replaced to reset the hour countdown. Power Off the machine.
4. Reinstall the Bulb Housing onto the UVGI Frame Assembly (see Bulb Housing Assembly Removal and Installation).
A - 10
INSTRUCTIONS FOR USE
Nilfisk Liberty SC50 UVGI - 56091240
2
7/2020