Renfert Twister Traduction Du Mode D'emploi D'origine page 29

6.3 Changing suction filter system
The suction filter system consists of a sponge filter (4) and a sinter
filter (13).
Vacuum can only build-up in a clean suction filter system.
Never operate the device without the complete suction filter!
6.3.1 Sponge filter
Pull the sponge filter (4) out in the direction of the base and replace with
a new sponge filter.
6.3.2 Sinter filter
⇒ Pull the sponge filter out in the direction of the base (Fig. 12).
⇒ Loosen the sinter filter (13) by turning counter-clockwise and remove.
⇒ Insert new sinter filter and tighten clockwise. The sinter filter should fit
tightly
⇒ Replace the sponge filter.
In previous devices (serial number index A) the sinter filter was only
plugged in. In this case, pull out the sinter filter downwards and push
the new sintered filter in until it stops.
The sinter filter can also be cleaned in the ultrasonic bath.
(Recommendation: Plaster solvent GO-2011, Art.no. 2011-0000).
6.4 Changing fuses
Before replacing a fuse, disconnect the appliance from the mains.
Never use a fuse of larger impedance.
⇒ Switch the appliance off�
⇒ Disconnect from mains�
⇒ Unlatch the fuse holder (6) on both sides and remove�
⇒ Change blown fuse�
⇒ Replace the fuse holder by sliding back into the socket until both sides
lock into place�
- 11 -
4
13
Fig. 11
4
Fig. 12
13
Fig. 13
6
Fig. 14
EN