Abicor Binzel ABIMIG 0 Série Mode D'emploi page 33

®
ABIMIG XX0/XX5
10 Disposal
1 Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2 Loosen the fixation of the liner or PA liner nipple at the end of the machine
and pull out or replace the liner or PA liner.
3 Remove wear parts from the torch neck and unscrew rotating or
changeable torch neck.
WARNING
Risk of injury
Injury caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable
protective clothing, in particular safety goggles.
®
4 Clean BIKOX cable assembly from both sides with compressed air.
5 Mount cleaned or replaced wear parts and liner or PA liner.
6 Connect cable assembly on the machine side to the wire feed unit.
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards
and guidelines.
10 Disposal
EN - 17