Abicor Binzel ABIMIG 0 Série Mode D'emploi page 29

®
ABIMIG XX0/XX5
5.3 Connecting the cable assembly
5.4 Setting the shielding gas volume
5.5 Feeding in the wire
1 Join the central connector and the central socket at the wire feeder.
2 Use the connection nut to secure both of these.
3 Attach the shielding gas and control lead connectors in the case of other
machine connections.
NOTICE
• The type and quantity of the shielding gas depends on the welding task
and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
NOTICE
• Each time the wire is replaced, make sure that the start of the wire is free
of burrs and not bent.
1 Lay the cable assembly connected to the machine side out straight.
2 Insert the wire into the wire feeder as specified by the manufacturer.
3 Press the 'zero-current wire feed' trigger on the wire feeder until the wire
comes out of the contact tip.
5 Putting into operation
EN - 13