Troubleshooting; Scrapping - Nilfisk Advance Terra 4300B Instructions D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The machine does not start when turning the
ignition key to "I".
The machine does not move when pressing
the pedal (2).
The main broom does not work.
The side brooms do not operate.
The machine operates only when stationary,
otherwise the red warning light (73) turns on.
The battery autonomy is low.
The dive system malfunction led (54) is
fl ashing.
For further information, refer to the Service Manual, available at any Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Batteries
– Engine oil
– Polyester dust fi lter
– Main and side brooms
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
24
INSTRUCTIONS FOR USE
The battery connector (46) is disconnected.
The F1 fuse in the box (51) is open.
The battery charger cable (48) is connected to
the electrical mains.
The parking brake is engaged.
When starting the machine with the ignition key
(72), the pedal (2) is pressed, or the operator is
not yet on the driver's seat.
The circuit breaker (52) is deactivated.
The main broom is not lowered.
The circuit breaker (53) is deactivated.
The batteries are discharged.
The batteries are dead.
The battery capacity is low.
The drive system is malfunctioning.
146 2810 000(2)2008-07
Possible cause
Terra™ 4300B
Remedy
Connect the battery connector.
Replace the F1 fuse.
Disconnect the battery charger cable from the
electrical mains.
Disengage the parking brake.
Start the machine with the ignition key (72),
only after being on the driver's seat and without
pressing the pedal (2).
Reset the fuse (52) by pressing the relevant
switch.
Lower the main broom.
Reset the fuse (53) by pressing the relevant
switch.
Charge the batteries.
If the problem persists, replace the battery.
Replace the batteries.
Buy batteries with higher capacity (see the
Technical Data paragraph).
To detect the failure, refer to the Service Manual
(at any Advance Service Center).