RC(S)(L)(D)10-Series
I
NOTE
• Attach the side walls or the attached strips so that the screws are
tight, even under increased loads (while driving).
• The refrigerator is designed to provide a regulated air flow. The
manufacturer does not recommend to leave additional space
between the refrigerator and the recess walls.
➤ Move the refrigerator into its final location with the front flange sitting tight
against the recess front.
➤ Fasten the screws (fig. 6, page 6) through the plastic bushings in the sides of
the refrigerator, and further into the wall.
➤ Put the caps onto the screw heads.
Installing the control panel of RC10.4P.100
➤ Install the control panel as shown (fig. 7, page 7).
4
Technical data
For the current EU declaration of conformity for your device please refer to the
respective product page on dometic.com or contact the manufacturer directly
(see dometic.com/dealer).
This device complies with UN ECE Regulation R10.
This product contains fluorinated greenhouse gases.
The cooling unit is hermetically sealed.
EN
Technical data
17