Speaker Configuration 1 - Teac AG-7D Manuel Du Propriétaire

3
1 2 4
1
2
3
4
5
32
5

Speaker Configuration 1

It is important to perform speaker configuration prior to using
the unit.
To enjoy multi-channel surround sound, such as 5.1, you need 5
speakers (Front Left, Center, Front Right, Surround Right,
Surround Left) and a powered sub-woofer.
In addition to above, you will need a surround back speaker for
6.1 channel surround sound.
< When no action is taken for 8 seconds, the Speaker Setup
mode will be cancelled.
1 Press the POWER switch.
The unit enters standby mode, and the STANDBY indicator
lights.
2 Press the STANDBY/ON switch to turn the unit on.
The STANDBY indicator goes off.
3 Press the SPEAKER SETUP button.
"SUB-W Y" or "SUB-W N" appears on the display.
Each time the SPEAKER SETUP button is pressed, the mode is
changed as follows:
sub-woofer setting
speaker size setting (Front)
speaker size setting (Center)
speaker size setting (Surround)
speaker size setting (Surround Back)
distance (Front Left)
distance (Front Right)
distance (Center)
distance (Surround Left)
distance (Surround Right)
distance (Surround Back)
Crossover Frequency
< The SPEAKER SETUP button will not work when the SPEAKER
button is set to off. In that case, press the SPEAKER button to
turn the speakers on and then press the SPEAKER SETUP
button.
< The SPEAKER SETUP button will not work when EXTERNAL IN
is selected. In that case, press the EXTERNAL IN button to turn
it off and then press the SPEAKER SETUP button.
4 Press the SELECT buttons to change the setting.
For details of each setting, see page 34 to 38.
3 4
Repeat step and to set other configurations.
5 When all the configurations has been finished, press the
MEMORY button (or the ENTER button of the remote
control unit) to save the changes and exit the Speaker
Setup mode.
Be sure to press the MEMORY button within 8 seconds, or
the changes will be cancelled.
ENGLISH