Tuner 1 - Teac AG-7D Manuel Du Propriétaire

1
1
2
3
4
68
3 2 4

Tuner 1

1 Select TUNER by turning the FUNCTION knob (or press
the TUNER button of the remote control unit).
Make sure the antennas have been connected (see page 6-8).
2
Select AM or FM by pressing the BAND button.
< If the BAND button is pressed while the source other than
TUNER was selected, the source will be switched to TUNER
automatically.
3
Press the TUNING MODE button to select the tuning
mode.
Each time the TUNING MODE button is pressed, the tuning
mode changes as follows:
Automatic tuning mode
("AUTO" indicator lights on the display.)
Manual tuning mode
(no indicator)
Preset tuning mode
("PRESET" indicator lights.)
Select the Manual tuning mode or the Automatic tuning
mode.
< When using the remote control unit, you can skip this step.
4 Press the TUNING/PRESET button to tune in a station.
In the Automatic tuning mode, the unit starts searching for a
station. When a station is tuned in, the tuning process will
stop automatically.
If you want to stop the tuning process, press the TUNING
MODE button.
In the Manual tuning mode, hold down the TUNING/PRESET
button and release it when the station is tuned in.
When the TUNING/PRESET button is pressed momentarily, the
frequency changes by a fixed step (FM: 50 kHz steps, AM: 9
kHz steps).
When using the remote control unit:
Hold down the SELECT button of the remote control unit for
more than 0.5 seconds.
When a station is tuned in, the tuning process will stop
automatically.
If you want to stop the tuning process, press the SELECT
button.
When the SELECT button of the remote control unit is
pressed momentarily (0.5 second or less), the frequency
changes by a fixed step.
Press the SELECT button repeatedly until the station you want
to listen to is found.
Repeat this step until the station you want to listen to
is found.
< "TUNED" is displayed when a broadcast is correctly tuned in.
ENGLISH