Dubbing From Video 2 Or 3 To Video 1; Dubbing The Audio And Video Signals Separately - Teac AG-7D Manuel Du Propriétaire

1
2
48

Dubbing from VIDEO 2 or 3 to VIDEO 1

1 Select VIDEO 2 or 3 by turning the FUNCTION knob.
2 Start recording on the VCR connected to VIDEO 1 REC
jacks.
3 Start playback on the VCR connected to VIDEO 2 or 3
INPUT jacks.
The audio and video signals input from VIDEO 2 or 3 are
output from VIDEO 1 REC jacks.
< Copy protected DVD discs cannot be dubbed.
< The video signal from S-VIDEO or VIDEO jacks cannot be
mixed. Be sure to connect all the components via the same
kind of jacks.

Dubbing the audio and video signals separately

While dubbing the video signal of VIDEO 2 or 3, you can
replace the sound from VCR with the sound from an audio
source such as CD.
1
Select the video source to be recorded (VIDEO 2 or 3)
using the FUNCTION buttons of the remote control unit.
2
Select the audio source to be recorded (CD, TAPE, etc.)
using the FUNCTION buttons of the remote control unit.
Do not turn the FUNCTION knob of the main unit, or the
video source selection in step
3
Start recording on the VCR connected to VIDEO 1 REC
jacks.
4
Start playback of the video and audio source to be
recorded.
The picture from the video component appears on the TV,
and the sound from the audio component is output from the
speakers.
ENGLISH
1 might be cancelled.