SilverCrest SMS 300 A1 Mode D'emploi Et Consignes De Sécurité page 37

Troubleshooting
This section contains important information on fault identification and
rectification . Follow the instructions to avoid hazards and damage .
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions . If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service) .
Fault
The appliance
does not suck .
The suction power
is too weak .
The UV-C lamp
does not light up .
The vibration
head
7
vibrate .
An unpleasant
odour escapes
from the appliance
during suction .
■ 34 │ GB │ IE
Cause
The appliance is not
switched on .
The plug is not plugged
in .
The mains socket is not
supplying power .
The dust container
full .
The dust filter
The suction opening
is blocked .
The automatic switch-off
device of the UV-C lamp
has been activated .
8 8
The UV-C lamp
appliance is defective .
The vibration function is
does not
not switched on .
Odours often develop
when new appliances
are used for the first time .
The appliance is
defective .
Remedy
Make sure that the appliance
is properly connected to the
power supply and press the
On/Off switch
Insert the power plug into the
socket .
Check the house fuses
is
3
Empty the dust container
is dirty . Clean the dust filter
4
Turn off the appliance, pull out
9
the plug from the wall socket
and remove the blockage .
Check the safety switches
left and right (see section
Safety switches) .
or Contact Customer Service (see
8
section Service) .
Press the vibration button
The smell should disappear
after the appliance has been
used a few times .
Switch off the appliance, pull
out the power plug from the
socket and contact Customer
Service (see section Service) .
.
2
.
3
.
4
0
.
w
SMS 300 A1