SilverCrest SMS 300 A1 Mode D'emploi Et Consignes De Sécurité page 32

Operation
WARNING! RISK OF INJURY!
► Never look into the UV-C lamp
► Never use the appliance on people or animals! UV radiation can lead to
injuries to eyes and skin .
► Only operate the appliance when it has been properly assembled .
This is the only way to avoid the dangers of UV radiation .
► Use this appliance only as described in these operating instructions .
This is the only way to avoid the dangers of UV radiation .
NOTE
► Use the appliance only if it is completely and correctly assembled . The
dust container
undamaged . If dirt gets into the motor of the unit, it could cause motor
damage .
► Make sure that the safety switches of the UV-C lamp
of the appliance are not blocked .
► Test the appliance on a small, unobtrusive spot first .
1) Plug the power plug into a properly installed, easily accessible wall outlet .
2) Place the appliance flat on the surface to be cleaned .
3) Press the On/Off switch
Make sure that the On/Off switch
The appliance starts vacuuming .
4) Press the vibration button
shakes up the surface to be cleaned and the swirled up dust is sucked in
through the suction opening
on the UV-C lamp
5) Move the appliance evenly over the surface to be cleaned .
6) After vacuuming, press the On/Off switch
7) Unplug the appliance from the mains socket .
SMS 300 A1
during use!
8
and the dust filter
3 4
to turn on the appliance .
2
2 fully engages .
to activate the vibration head
w
. Pressing the vibration button
9
.
8
must be inserted correctly and
on the underside
8
. The vibration
7
w
to turn off the appliance .
2
GB │ IE
also switches
│ 29 ■