Toro Recycler 53cm Manuel page 22

Maintaining the Blade
Always mow with a sharp blade. A sharp blade cuts
cleanly and without tearing or shredding the grass
blades.
Preparing the Machine
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Drain the fuel from the fuel tank.
4. Tip the machine onto its right side (air cleaner
up) as shown in Figure
Figure 24
1. Blade
2. Accelerator
Inspecting the Blade
Service Interval: Before each use or daily—Inspect
the mower blades for wear or
damage.
Carefully examine the blade for sharpness and wear,
especially where the flat and the curved parts meet
(Figure 25A). Because sand and abrasive material
can wear away the metal that connects the flat and
curved parts of the blade, check the blade before
using the machine. If you notice a slot or wear
25B and Figure 25C), replace the blade; refer to
Removing the Blade (page
24.
g024253
3. Blade bolt and lock washer
(Figure
22).
1. Sail
2. Flat part of the blade
Note:
For the best performance, install a new blade
before the mowing season begins. During the year,
file down any small nicks to maintain the cutting edge.
DANGER
A worn or damaged blade can break, and a
piece of the blade could be thrown toward you
or bystanders, resulting in serious personal
injury or death.
• Inspect the blade periodically for wear or
damage.
• Replace a worn or damaged blade.
Inspecting the Accelerator
Service Interval: Before each use or daily—Inspect
the accelerator for wear or damage.
Carefully examine the accelerator for excessive wear
(Figure 26). Because sand and abrasive material can
wear away the metal (especially in the area shown
as item 2 in Figure 26), check the accelerator before
using the machine. If you notice that a tab on the
accelerator has been worn down to a sharp edge
or there is a crack, replace the accelerator; refer to
Removing the Blade (page
1. Accelerator
2. Wear area
21
Figure 25
3. Wear
4. Slot formed
22).
Figure 26
3. Tab
4. Crack formed
g002278
g027496