Publicité
Les langues disponibles
Les langues disponibles
FreshWell2000
7.3
Installing the fastening brackets and the belts
See fig. 6
➤ Fasten the four fastening brackets (A).
➤ Pull the belts through the fastening brackets (B).
➤ Install the drain pipe under the under-bench air conditioner (C).
➤ Fasten the under-bench air conditioner with the belts (D).
7.4
Installing the angle section
See fig. 7
➤ Fasten the under-bench air conditioner with the two angle sections an
three fastening screw for each as shown.
7.5
Installing the receiver
See fig. 8
➤ Drill an opening of 50 mm into the wall.
See fig. 9
➤ Lay the cable through the hole to the under-bench air conditioner.
➤ Fasten the receiver as shown.
7.6
Laying the connecting cables
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
The under-bench air conditioner must be connected to an electric circuit
which is able to supply the required current (see chapter "Technical data" on
page 16).
➤ Select the cross-section of the cable corresponding to the length:
– Length < 7.5 m: 1.5 mm²
– Length > 7.5 m: 2.5 mm²
EN
Installation
11
Publicité
