Technical Specifications; General Warning - Tractel blocfor 1.8 EVO ESD-EN 360 Manuel D'installation, D'emploi Et D'entretien

Technical specifications

Model B1.8 A EVO ESD
Weight (kg)
Strap length (m)
Strap width (mm)
Pull back force (N)
Horizontal use
L Min (m)
M Max (m)
Device attachment
Strap attachment

1. General warning

1. Before using your blocfor™ self-retracting fall-
arrester device, and to ensure safe, efficient use of
the harness, it is essential that the supervisor and
operator have read and understood the information
given in the manual supplied by TRACTEL SAS.
This manual should be available at all times to all
operators. Additional copies can be supplied on
request.
2. Before use, it is essential that operators are trained
in the use of this safety device. Check the state of
associated equipment and make sure that there is
adequate room for movement.
3. The blocfor™ self-retracting fall-arrester must only
be used by a single trained and skilled operator, or
by an operator under supervision of a supervisor.
4. Any blocfor™ self-retracting fall-arrester device
which does not appear to be in good condition
or which has already served to stop a fall should
be inspected, with all its associated equipment,
by TRACTEL SAS or by a qualified technician
who must give written authorisation for re-use of
the system. It is recommended to make a visual
inspection prior to each use.
5. Any modification or attachment made to the
equipment cannot be done without prior written
approval from TRACTEL SAS. The equipment must
be transported and stored in its original packaging.
6. Any blocfor™ self-retracting fall-arrester which
has not been inspected over the past 12 months
(or in accordance with the statutory inspection
requirement of the country of use) or which has
served to stop a fall must not be used. They can
only be used again after a new periodical inspection
carried out by an approved and competent
technician who can offer written permission for use.
Failing these reviews and approvals, the blocfor™
self-retracting fall-arrester will be disassembled and
destroyed.Safety of the operator is closely allied to
maintaining efficiency and resistance of equipment.
B1.8 B EVO ESD
1.16 1.55
1.8 2
20 20
5 to 25 5 to 25
OK OK
1 1
0.5 0.5
Anchor point Operator
Operator Anchor point
7. The maximum working load for the blocfor™ self-
retracting fall-arrester is 150 kg.
8. If the mass of the operator increased by the weight
of their equipment and tools is between 100 kg
and 150 kg, you must ensure that the total weight
(operator, equipment + tools) does not exceed the
maximum load of each of the components of the
fall-arrest system.
9. This device is suitable for use on an open air site
and for a temperature range of -30°C to +50°C.
Avoid any contact with sharp edges, rough surfaces
and chemical substances.
10. If you are responsible for assigning the equipment
to an employee or similar person, ensure that you
comply with the applicable health and safety at work
regulations.
11. The operator must be physically and mentally fit
when using this equipment. In case of doubt, check
with one's private doctor or with the works doctor. It
is forbidden for use by pregnant women.
12. The equipment should not be used beyond its limits
or in any other situation other than what it has been
designed for (cf. "4. Functions and Description").
13. The blocfor™ self-retracting fall-arrester systems
should be personally assigned to each operator, in
particular where salaried personnel are concerned.
14. Before using a EN 363 fall-arrester device, the
operator must ensure that each of the components
is in good working order: security system, locking
system. During installation, no damage should be
made to any of the security functions.
15. In a fall-arrester system, it is essential to verify, prior
to each use, the free space under the operator in
the workplace, to avoid any risk of collision, in the
case of a fall, with the ground or with any obstacle
found in its path.
16. An anti-fall harness is the only body-gripping device
that is permitted for use in a fall-arrester system.
17. It is essential for the safety of the operator that the
device or anchoring point is correctly positioned and
that work is carried out so as to minimise the risk of
falls from height.
18. For the safety of the operator, if the equipment is sold
outside the first country of destination, the dealer
should supply: an instructions manual, instructions
for maintenance, for periodical inspections and
repairs, all compiled in the language of the country
of use.
19. Exposure of an Aramid strap to UV considerably
reduces its resistance, it is necessary to multiply the
precautions during use, but also inspections, and
assessment of the wear and the service life of the
equipment.
GB
3